Installation Requirements - FS IES3110-8TF Schnellstartanleitung

LEDs
P1
P2
SYSTEM Fault
Ring
R.O.
LINK/ACT
RJ45
1000
LINK/ACT
SFP
1000

Installation Requirements

Before you begin the installation, make sure that you have the following:
Workstations running Windows XP/2003/Vista/7/8/10/2008, MAC OS X or later, Linux, UNIX, or
other platforms are compatible with TCP/IP protocols.
Workstations are installed with Ethernet NIC (Network Interface Card).
Ethernet Port Connection
Network cables -- Use standard network (UTP) cables with RJ45 connectors.
The above PC is installed with Web browser.
NOTE: It is recommended to use Internet Explorer 8.0 or above to access the switch. If the
web interface of the Industrial Managed Switch is not accessible, please turn off the
anti-virus software or firewall and then try it again.
4
Status Description
Green Indicates the Switch has power.
Green Indicates the Switch has power.
Green Indicates power failure.
Green Indicates that the ERPS Ring has been created successfully.
Indicates that Switch has been enabled to Ring Owner.
Green
Indicates the link through that port is successfully
Light
established.
Green
Indicates that the Switch is actively sending or receiving
Blink
data over that port.
Indicates that the port is successfully connecting to the
Light
network at 1000Mbps.
Orange
Indicates that the port is successfully connecting to the
Off
network at 10Mbps or 100Mbps.
Indicates the link through that port is successfully
Light
established.
Green
Indicates that the Switch is actively sending or receiving
Blink
data over that port.
Indicates that the port is successfully connecting to the
Light
network at 1000Mbps.
Orange
Indicates that the port is successfully connecting to the
Off
network at 100Mbps.