Axis Communications Q60-Serie Installationsanleitung Seite 15

All manuals and user guides at all-guides.com
network devices are installed in accordance with the manufacturer's instructions. For
information about regulatory requirements, see Electromagnetic compatibility (EMC)
on page 2.
• Mount the product with the dome cover facing downward.
• Be careful not to scratch, damage or leave fingerprints on the dome cover because this
could decrease image quality. If possible, keep the protective plastic on the dome cover
until the installation is complete.
Attach the sunshield (optional)
The sunshield protects the camera against UV light and helps keep the temperature inside the
camera down.
1. Slide the sunshield over the unit holders on the camera unit.
2. Secure the sunshield using the supplied screws (T20).
Change the dome cover (optional)
The premounted clear dome cover can be replaced if you want to use a smoked dome cover or if the
dome cover is scratched or damaged. Smoked dome covers and spare clear dome covers can be
purchased from your Axis reseller.
For location of the components, see Hardware overview on page 10.
1. Loosen the dome ring screws and remove the dome cover.
2. Remove the dome bracket screws, the dome bracket, and the dome cover from the dome
ring.
3. Make sure the rubber gasket is fitted correctly on the dome cover.
4. Align the bulge on the dome cover with one of the logotypes on the dome ring.
5. Attach the dome bracket and the dome cover to the dome ring and tighten the screws
(torque 1.2 Nm).
6. To install an SD card, see How to install an SD card (optional) on page 15.
7. To attach the dome cover to the top cover, align the bulge on the dome cover with the
heater on the camera unit and tighten the screws (torque 1.5 Nm).
How to install an SD card (optional)
Installing an SD card is optional. A standard or high capacity SD card (not included) can be used to
store recordings locally in the product.
1. Loosen the dome ring screws and remove the dome cover.
2. Insert an SD card into the SD card slot.
3. To attach the dome cover to the top cover, align the bulge on the dome cover with the
heater on the camera unit and tighten the screws (torque 1.5 Nm).
AXIS Q60-E Series
15