Telephone Programming (Depending On Kit Version) - Fermax 6030 Handbuch

Kit VIDEO DIGITAL
Kit VIDEO DIGITAL
TELEPHONE PROGRAMMING (Available depending on Kit version)
Once the telephone is connected, take the following programming steps:
1. With the hang-up button pressed, press
the PROG Programming Button (a
beep is heard) until you hear a
confirmation tone (similar to a call tone).
Communication with the Outdoor Panel
is established immediately. The arm
handset must be plugged in.
The time between steps 1 and 2 must be less than 4 minutes. If this time is exceeded,
start the sequence again.
VERY IMPORTANT NOTE
The telephone will not work until it has been programmed.
The whole programming process can be done with the phone hung up. If it is
done with the phone hung up, when it is hung up the call will be cut off, even if
it has not finished.
All manuals and user guides at all-guides.com
hang-up button
2. Press the house call button.
Hang up the telephone handset and
check the programming by making a
call to the house.
Pag 29