Cleaning And Maintenance - BRAYER BR3209 Sicherheitshinweise Und Bedienungsanleitung

6 EN
• Wipe the unit with a clean, slightly damp cloth to
remove dust, and then wipe it dry.
• Unwind the power cord to its full length while using
the unit.
USAGE
To achieve good results, wash your hair with shampoo,
wipe with a dry towel, dry with a hairdryer and comb it.
After that you can curl your hair.
• Divide the hair into locks 4-5 cm wide.
• Put the unit on the safety stand (3) on a flat heat-
resistant surface.
• Insert the power plug into the mains socket.
• Switch the unit on by setting the power switch (6) to
the position «ON», the light indicator (5) will light up.
• Wait for some time until the operating surface (2)
heats up.
• Take a hair lock with the free hand.
• Press the clamp handle (4) with the other hand,
place the end of the hair lock on the operating
surface (2) and release the clamp handle (4).
Holding the tip (1) and the handle (7), wind the lock
around the operating surface (2).
• Wait for a while, then press the clamp handle (4)
and release the hair lock.
• Repeat this procedure on the rest of your hair.
• Notes:
- when using the unit for the first time, a foreign
smell from the heating element can appear — this
is normal and it is not covered by warranty.
- avoid contact of hot surfaces of the unit with your
face, neck and other parts of your body during the
unit operation.
- during breaks in operation, place the unit on the
safety stand (3) on a flat heat-resistant surface.
- do not comb the hair right after curling it, let it
cool down, hair spray should be applied after hair
curling.
• After finishing the unit operation, switch the unit
off by setting the power switch (6) to the «OFF»
position, and unplug the unit.
• Put the unit on the safety stand (3) on a flat heat-
resistant surface and let it cool down completely.

CLEANING AND MAINTENANCE

• Before cleaning unplug the unit and let it cool down
completely.
• Do not immerse the unit, power cord and power
plug into water or any other liquids.
• Do not use detergents, abrasives or any solvents to
clean the unit.
• Wipe the unit body with a soft, slightly damp cloth
and then wipe it dry.