Connecting The Device To A Bluetooth Audio Source; Initial Operation - Magnat RV 4 Wichtige Hinweise Zur Installation / Garantieurkunde

20 PHONO MM input
Connection of a record player with a magnet
system (MM) or MC system with high output
level (high output MC).
21 PHONO MC input
Connection of a record player with Moving Coil
System (MC).

CONNECTING THE DEVICE TO A BLUETOOTH AUDIO SOURCE

Select Bluetooth input. If you have previously
connected a Bluetooth device, the RV 4
will automatically attempt to re-establish a
connection with this device. If this is the case,
you may be required to manually reconfirm the
connection on the source device.
If a connection has not already been made
or the connection cannot be re-established,
the RV 4 will automatically activate the
‚pairing mode'. In the display appears „NOT
CONNECTED".
Now activate the Bluetooth mode on your
source device. The RV 4 will appear in the
list of Bluetooth devices as „RV 4". If it is not
displayed in the list, set your source device
to search for Bluetooth devices manually and
make sure that the RV 4 has been switched to
the pairing mode.
Depending on the source device, you may be
asked whether the password is to be accepted
during the pairing procedure. You can confirm
this by simply pressing „Accept". If you are
still asked for a password, use the default
passwords „0000" or „1234". If you are asked
if you want to establish a connection after
pairing, please select „Yes". When the device
has been paired and connected successfully
the „NOT CONNECTED" will disappear.
If an audio signal is not available, the message
„NO SIGNAL" will appear in the display.
22 PHONO earth connection
Connection of the phono cable's earth wire in
order to prevent humming.
The RV 4 supports the Qualcomm® aptX™
high quality audio transmission standard.
If your source device also supports this
standard, Qualcomm® aptX™ will be selected
automatically as the transfer mode when
establishing a Bluetooth connection. In the
display appears „aptX".
Autogoods "130"
OPERATIONAL ELEMENTS AND CONNECTIONS – REMOTE CONTROL
• Before using the remote control you will need to insert the supplied batteries (accessory No. 3):
• Use the supplied screwdriver (accessory No. 5) to remove the rear of the remote control.
• Insert the batteries into the battery compartment. When doing this pay attention to the correct
polarity of the batteries.
• Replace the rear and tighten the screws.
• If the batteries have run out after prolonged use, please replace them (type AAA).
23 Source
This button enables direct selection of the individual audio inputs.
23 24
The active input is indicated in the display.
24 Mute
25
You can mute the sound using this button. The sound can be
reactivated by pressing this button again.
25 Volume
Increases (5) or decreases (6) the volume.

INITIAL OPERATION

• Place the RV 4 on an even surface. Observe the relevant clearance gaps as specified under
„Important safety instructions".
IMPORTANT: Do not place any objects on top of the device (magazines, CD/record cases, etc.).
• Connect your speakers:
The stereo speakers (impedance of 4 to 8 ohms) are connected to the rear as follows:
11