Cleaning And Maintenance - BOMANN WA 5721.1 Bedienungsanleitung, Garantie

Capacity
Do not overload the appliance otherwise the laundry
is not getting clean. Refer to the information in the
"Program table".
Starting the program
 Connect the appliance to the power supply and
switch it on.
 The water supply must be opened to the maxi-
mum pressure.
 Load your laundry and fill in the detergent, if nec-
essary.
 Close the appliance door properly.
 Set the required washing conditions.
 Start the operation.
Appliance door lock
Once a wash program has been started, the appli-
ance door cannot be opened.
When the wash cycle is finished, the door lock will
automatically be unlocked.
Refill laundry
WARNUNG:
Never attempt to force open the appliance door dur-
ing operation.
After the program has started, you can refill or re-
move laundry as needed. Interrupt the washing pro-
cess with the START/PAUSE button. The appliance
checks whether a refueling is possible and, if neces-
sary, releases the door lock after a short time.
As soon as the water temperature or the water level
exceeds a certain value, the door remains locked for
safety reasons and cannot be refilled.
Changing the program
 To change the program, first interrupt the washing
process.
 Switch the device briefly off and then on again.
All manuals and user guides at all-guides.com
 Select the desired program and start the new
End of program
At the end of the wash cycle several beeps sound; a
few minutes later, the appliance enters standby
mode. The door lock is unlocked.
Switching off
 Switch off the appliance.
 Close the water supply!
 Leave the appliance door slightly open until the
 If the appliance is not in use for an extended peri-
Energy saving tips
 If possible avoid the selection of high wash tem-
 Select the wash program depending on the type
 Take advantage of the maximum capacity of each
 Clean the filter regularly to avoid excessive wash-
 Ventilate the room well. The room temperature
 Always switch off the appliance and disconnect it
 Allow the appliance to cool down enough before
 Do not use steam cleaners for cleaning the appli-
30
operation.
next wash cycle to avoid odors.
od, disconnect the mains plug or switch off or turn
out the fuse.
peratures. Modern detergents achieve good
washing results even at low temperatures.
of laundry and the required degree of washing.
wash program.
ing and high energy consumption.
should not rise above +35°C.

Cleaning and Maintenance

WARNING:
from the power supply before cleaning and user
maintenance.
cleaning. Scalding!
ance; moisture could enter electrical components.