Protective Circuit; Notes On Installation - auna Silverhammer4 Bedienungsanleitung

• Do not install the amplifier where:
- exposed to direct sunlight or high temperatures.
- exposed to rain or moisture.
- this is exposed to dust and dirt. If the car has heated up in the sun,
let it cool down before use.
• If the appliance is installed horizontally, the cooling fins must not be
covered by the floor carpet.
• If the appliance is installed too close to the radio, it may interfere with
it.
• If there is no power to the appliance, check the connections.
• The appliance has a protection circuit that protects the transistors and
speakers in case of malfunction.
• Never attempt to test this protective circuit.
• For safety reasons, always set the volume so that you can still hear the
outside noise.

PROTECTIVE CIRCUIT

The circuit protects the appliance from:
• Overheating.
• Overvoltage.
• Short circuit
In this case, the fuse lamp lights up red and the appliance switches off. If
this happens, switch off the connected accessories and try to find the cause.
If the appliance is overheated, let it cool down for a while.

NOTES ON INSTALLATION

• The appliance is installed either under a seat or in the boot.
• Mount the appliance in such a way that the driver's movements are not
restricted and the appliance is not exposed to direct sunlight or heat.
• Do not install the appliance under the floor carpet as it may cause heat
accumulation.
EN
27