Troubleshooting; Possible Cause - Scheppach HM216SPX Original Bedienungsanleitung

15. Troubleshooting

Fault
Motor does not work
The motor starts up
slowly and does not reach
operating speed.
Motor makes excessive
noise
The engine does not reach
full power.
Motor overheats easily.
Saw cut is rough or wavy
Workpiece pulls away and/
or splinters
40 | GB

Possible cause

Motor, cable or plug defective,
fuses burnt
Voltage too low, coils damaged,
capacitor burnt
Coils damaged, motor defective
Circuits in the network are
overloaded (lamps, other motors,
etc.)
Overloading of the motor,
insufficient cooling of the motor
Saw blade dull, tooth shape
not appropriate for the material
thickness
Excessive cutting pressure and/or
saw blade not suitable for use
www.scheppach.com
Remedy
Arrange for inspection of the machine by a
specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Have an electrician check the voltage.
Arrange for inspection of the motor by a
specialist. Arrange for replacement of the
capacitor by a specialist
Arrange for inspection of the motor by a
specialist
Do not use any other equipment or motors on
the same circuit
Avoid overloading the motor while cutting,
remove dust from the motor in order to ensure
optimal cooling of the motor
Re-sharpen saw blade and/or use suitable saw
blade
Insert suitable saw blade