Installation; The Right Place For Installation; Attaching The Plastic Wedges - Beko GN163140ZGBN Bedienungsanleitung

4

Installation

4.1 The right place for installation

A
Read the "Safety Instructions" section first!
Your product requires adequate air circulation to
function efficiently. If the product will be placed in an
alcove, remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls.
If the product will be placed in an alcove, remember
to leave at least 5 cm clearance between the
product and the ceiling, rear wall and the side
walls. Check if the rear wall clearance protection
component is present at its location (if provided with
the product). If the component is not available, or
if it is lost or fallen, position the product so that at
least 5 cm clearance shall be left between the rear
surface of the product and the wall of the room.
The clearance at the rear is important for efficient
operation of the product.
A
WARNING:
sockets in power connection.
B
WARNING:
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
WARNING:
A
narrow for the product to pass, remove
the door and turn the product sideways; if
this does not work, contact the authorized
service.
vibration.
the heater, stove and similar sources of heat
and at least 5 cm away from electric ovens.
keep in damp environments.
Do not use extension or multi
The manufacturer assumes
The product's power cable
: If the door span is too
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.

4.2 Attaching the plastic wedges

Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1. To attach the wedges, remove the screws on
the product and use the screws provided with the
wedges.
2. Attach 2 plastic wedges on the ventilation cover as
shown in the figure.
10 /29 EN
Refrigerator / User Guide