Locomotive Settings; Cv-List Of The S 160 - roco S 160 2610 USATC Handbuch

▪ Locomotive Settings

The Sounddecoder has been optimally adjusted to this locomotive. You can still adapt numerous decoder properties to your wishes however.
Certain parameters (referred to as CVs – Configuration Variable – or register) can be amended.
Please check before each programming if this is really necessary. Incorrect settings can result in the decoder not reacting correctly.
The decoder is preprogrammed with 28/128 speed steps at the factory for a high level of comfort. This means that it can be used together with
all of the modern DCC (MULTIMAUS) and Motorola
The Sounddecoder has been especially modified for the additional functions and must not be
replaced with a decoder which is available from a retailer.
If the locomotive is to be reprogrammed, only the locomotive is to be on the programming track.

▪ CV-List of the S 160

CV Name
1 Address (= short address)
2 Minimum speed (lowest creeping speed)
3 Start-up delay (from standstill to maximum speed)
4 Braking delay (from maximum speed to stand-still)
5 Maximum speed
72154.indd 37 72154.indd 37
control devices.
®
Value Default Value
01 – 99 3
01 – 252 8
00 – 255 30
00 – 255 16
00 – 252 160
37
30.11.2021 09:27:40 30.11.2021 09:27:40