Improper Use - McBULL 9354 Bedienungsanleitung

The balancer must be installed before use. This operation must be carried out by skilled staff
in compliance with the instructions contained in this manual.
INCORRECT INSTALLATION CAN CAUSE INJURY/DAMAGE TO PERSONS AND/OR PROPERTY.
This manual contains important information that allows the appliance to be used in safe conditions.
Make sure all instructions are fully understood before using the balancer.
FAILURE TO COMPLY WITH THIS RECOMMENDATION COULD CAUSE INJURY.
The balancer was manufactured in compliance with European Community Directives pertinent and applicable
at the time it was introduced onto the market, which envision CE marking of the product.
D U
eclared se
The balancers are designed to balance the weight of tools and utensils in general. The balancer is to be
used by one operator at a time. The balancer can be used in assembly lines, in individual work positions, in
professional or private environments, for hobbies, etc.
Always use, control and keep the balancer in perfect working order, in compliance with all regulations
pertinent to the balancers, tools and work places.
Balancer capacity from minimum to maximum value expressed in kg;
Length of the balancer cable expressed in mm;
Mass of the balancer in kg.
McBULL is not liable regarding those customers that use this balancer for other applications.
I U
mproper se
Do not use the balancer in environments with potentially explosive atmosphere.
Do not allow minors to use the balancer.
Do not operate, transit or stop under the balancer.
C T B
hoosing he alancer
Assess the total load to balance: tool, accessories and parts of pipes or cables supported by the balancer.
The total load to be balanced must be between the minimum and maximum capacity of the balancer.
C T
ommissioning he
Assess the range of the work area and, if necessary, hang the balancer on a carriage in order to use it correctly
in an area large enough to carry out the required activities
If screw-fixing devices are used for installation, self-locking nuts, split-pins or other safety systems must be
used.
Always connect the safety suspension (S), with exclusive use of the supplied standard fittings
(Fig.1), to a suitably sized support. The safety support MUST NOT BE the same one used for
the main suspension (33) (Fig.1). If the main suspension breaks, the max falling distance must
not be more than 100 mm. Tighten the nuts of the clamps 20331 (Fig.1) with a torque of 4 Nm.
To prevent anomalous wear, the load must be applied vertically. The balancer must be free to move in its
suspension in a way that it can line up with the direction of the load.
U T B
sing he alancer
Grip the tool hanging from the balancer and carry out the required operations. Then accompany the tool until
it balances, on the vertical line of the balancer, and release it.
The load to be balanced must be hung on snap-hook (29) (Fig.4). Ensure that the snap-hook is
B
alancer
... wir bewegen was !!!
Seite 17