Getting Started; The Remote Control System - GM-Racing MINI B16 Bedienungsanleitung

IMPORTANT
• Check all the screws are tight before using the car! Check all the screws are still tight after every battery pack used
in the car!
• RECOMMENDED:

GETTING STARTED

1. INSTALLING TRANSMITTER BATTERIES:
and proper installation of your batteries by switching the transmitter to ON. On vehicle transmitters, you should see
the Power LED light up. If you do not, your batteries may be low on voltage or you may not have installed them all
correctly. As the life of your transmitter batteries begins to decline, the Power LED will become darker. When you
notice that, this is a caution sign that it is time to install new batteries. Your vehicle may easily travel out of range
causing you to lose all con-trol, which could result in a collision causing damage to the vehicle or other property.
2. CHARGING YOUR VEHICLE:
only plug in one direction) and then plug the charger into a standard wall outlet. Charging takes approximately 60 -
90 minutes. When starting the charging process, two red LED will lit. The Battery pack is fully charged, if the second
LED goes from red to green.
When the battery is charged unplug the charger and connect the battery to your speed control battery's connect
plug. Your vehicle charger will safely charge your battery pack and not over charge it. Be careful when using after
market chargers that you do not overcharge the battery pack and ruin it.
3. ASSEMBLING THE ANTENNA:
wire up through the rear antenna mount hole in the upper chassis plate and begin feeding it into the plastic antenna
tube until it comes out the other side. Pull the remaining wire through the tube, and then press the tube into the
antenna mount in the upper chassis plate. Bend the antenna wire down around the tube and install the black rubber
antenna cap on the top of the tube. You may then wrap the remaining wire around the tube. DO NOT cut the antenna
wire off! This could shorten the range of your radio system.

THE REMOTE CONTROL SYSTEM

In the vehicle the GM-Racing XG-6 sport Spec is inserted. For this remote control a separate manual is attached.
RUNNING MULTIPLE VEHICLE
If you have some vehicles that would like to get a vehicle of their own or already have friends with other vehicles that
you will be racing, it is very important that you fi rst check what frequency channel your ve-hicle is on and confi rm that
none of your friends have the same frequency as yours. If you do fi nd that someone else is using the same frequency
channel that you are, you must wait for them to turn their transmitter and vehicle OFF or you may choose to change the
frequency crystals in your transmitter and receiver (so that you can run together at the same time without causing any ra-
dio interference). Addi-tional frequency crystal sets can be purchased separately and installed in a few quick seconds.
To change frequency crystals simply remove the black plastic crystal holder from the back of your transmitter by carefully
pulling it straight out. Slide the crystal out of the holder and install the new crystal labelled „Tx" in its place. Then carefully
align the two pins that extend from the transmitter, and gently press it into place. DO NOT force the crystal! The pins can
easily be broken! Remove the crystal from your receiver in the same careful manner using a pair of needle-nose pliers
and install the new „Rx" crystal in its place.
PLEASE NOTE: It is very important that the crystal labelled „Tx" is installed in the transmitter and the crystal marked
„Rx" is installed in the receiver.
GM-Racing Mini B16 - ST16
All manuals and user guides at all-guides.com
Use thread lock on all screws that work loose.
Install 8 new „AA" batteries into your vehicle transmitter. Check the life
Charge your vehicle's battery pack. Connect the charger to your battery pack (it will
Locate the plastic antenna tube (found inside the manual bag). Run the antenna
06