Operation - Klarstein WONDERSKY Bedienungsanleitung

OPERATION

Establish connection between thermostat and heater
• Step 1:
Switch on the heater. Press the P button on the control box on the back of the
heater twice. The pairing signal light (green light) will start flashing.
• Step 2:
Switch on the thermostat. Press and hold the light button for 5 seconds in
heating mode "88" will be displayed on the screen.
• Step 3:
At the same time, the pairing signal light on the unit will stop flashing. This
means that the connection between the unit and the thermostat has been
successfully established. The unit can now be adjusted via the thermostat.
Note: If you are using more than one heater, repeat the above steps for
all heaters. After successful pairing, all heaters can be controlled via the
thermostat.
Disconnect the connection between thermostat and heater
If you want to disconnect the thermostat from a heater, press the P button on the
heater twice. The pairing signal light will again start flashing.
Set day of the week/time and temperature calibration
• Switch on the thermostat. Keep the SET button pressed until the day of the
week display (W8) starts flashing. Adjust the day of the week by pressing the +
and - buttons. "W1" to "W7" refers to the weekdays from Monday to Sunday.
• Press the SET button again to set the time. Press the + and - buttons to adjust
the time setting.
• Press the SET button again to enter the temperature calibration setting (range
+5/-5 degrees). Temperature calibration is only necessary if the displayed
room temperature deviates from the actual room temperature.
EN
27