Assembling The Bed - Quax MY HOME 0101D001 Bauanleitung

4. Assembling the bed

Step 4.1 : Use both lower cross bars 1, both upper cross bars 4, both lateral cross bars 3, both front rafters 7L and 7R,
both rear rafters 6L and 6R, both frontal posts 2L and 2R, both rear posts 5L and 5R, eight wooden dowels A1, twenty
eight wooden dowels A2 and eighteen Maxifi xes E
Push two wooden dowels (A1) into the outer drillings on top of the posts (2L, 2R, 5L and 5R). Push two wooden dowels
(A2) into the drillings on each end of the cross bars (1 and 4). Push two wooden dowels (A2) into the holes on each end
of the lateral cross bars (3). Push two wooden dowels (A2) into the drillings at the top of the rafters (6L and 6R). Push
a maxifi x (E) into the holes on the ends on the inside of the cross bars (1 and 4). Push a maxifi x (E) into the drillings on
the ends on the inside of the lateral bars (3). Push a maxifi x (E) into the holes on the ends on the inside of the rafters (6L
and 6R). Push a maxifi x (E) into the drilling on the bottom end of the rafters (7L and 7R).
Quax nv Karel Picquélaan 84 B-9800 Deinze Belgium T
MY HOME 0101D001
Step 4.2 : Use of step 4.1 both frontal uprights 2L and 2R, both rear uprights
5L and 5R, both front rafters 7L and 7R, and eighteen connectors D
Tighten two connectors (D) in the central drillings at the top of the uprights (2L
and 2R). Tighten a connector (D) in the central drilling on top of the uprights
(5L and 5R). Now choose the mattress position at fl oor height (V1) or higher
(V2). For version 1 : Tighten two connectors (D) in the central holes at the
bottom of the uprights (2L, 2R, 5L and 5R). For version 2 : Tighten two con-
nectors (D) in the second row of central drillings at the bottom of the uprights
(2L, 2R, 5L and 5R). Tighten two connectors (D) in the central holes at the top
of the rafters (7L and 7R).
T 0032 9 380 80 95
29
www.quax.eu - E E info@quax.eu