Outwell ORION LUX Bedienungsanleitung

ORION LUX
MODEL: 650865 ( CREAM WHITE )
MODEL: 650867 ( LIME GREEN )
1. BUTTON
7. LAMP BODY
2. LAMPSHADE
( EXTENDED )
6. EDGE OF LAMPSHADE
8. REMOTE CONTROL
UK: INSTRUCTION MANUAL
Light modes:
• Press the button (1.) to switch on / off
the light.
• Press and hold the button to dim the
light. The light can be dimmed stepless
to any setting between maximum and
minimum light output.
• Press the ON button on the remote (8.)
to switch on the light.
• Press the OFF button on the remote
(8.) to switch off the light.
• When using the remote, the dim
setting selected on the (lamp) button
4. ADJUSTABLE
(1.) will be remembered.
HANGING POINT
Use of the lamp:
• Lamp is powered by 5V DC.
• Lamp can be powered by any 5V USB
output, or by the supplied AC/DC
adapter (5.).
• To extend lantern lampshade, grab
5. AC/DC ADAPTER
the edge of the lampshade (6.) and
push the body out from the inside, do
not pull on the cord. To collapse the
lampshade, reverse the above.
• Hang lamp from the hanging point,
adjust height as needed by gently
moving the cord through the adjuster.
• For indoor use only.
• Lamp can be cleaned
with a damp rag.
• Do not use corrosive
liquids to clean the lamp.
• Do not stare into the light source.
Light source: LED
This product contains a light
3. LAMPSHADE
source of energy efficiency
( COLLAPSED )
class E.
Light source and control
gear is not replaceable. This would intro-
duce weak points in the construction, that
could reduce the lifetime of the product.
Instruction for removal of light source
and control gear by market surveil-
lance authorities:
1) Remove lamp lens by using a flathead
screwdriver to open the four tabs.
2) Unscrew 2 pcs screws holding PCB
with LEDs in place.
3) Cut needed wires to remove the
required components for testing.
Instruction for disassembly of lamp
for disposal of components
when lamp has reached the
end of its usable life:
- See steps 1-2 above
3) Cut wires and remove
screws to allow removal of electronics
on circuit board. Dispose of electro-
nics according to local regulations.
4) Dispose of remaining components
according to local regulations.
Technical data (lamp):
5V
Class 3 appliance
Remote:
12W (1x12V MN21)
Class 3 appliance
AC/DC adaptor:
Input (AC/DC adaptor):
100-240V , 0.3A
Output (AC/DC adaptor):
5V , 2A
Class 2 appliance