auna Silverstar Bedienungsanleitung Seite 52

EN
52
Now playing information
While a FM station is playing, the screen shows one of the two following
sets data:
• If RDS information is available, by default the service name (i.e. station
name) is displayed. You can cycle through further RDS information
by pressing Info. Each time you press Info, another set of information
is displayed, cycling through RDS radio text, RDS programme type,
frequency and today's date.
• If no RDS information is available, the currently tuned frequency is
shown.
Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan setting to
stop only at stations with good signal strength, select Menu > Scan setting
> Strong stations only? > Yes
Audio Settings
By default, all stereo stations are reproduced in stereo. For weak stations,
this may result in a poor signal-to-noise ratio (hiss). To play weak stations
in mono, select Menu > Audio setting > FM weak reception: Listen in mono
only > Yes.