Useful Facts; Commissioning - IKA ULTRA-TURRAX Tube Drive Betriebsanleitung

Useful facts

Changes in viscosity and volume caused by processing of dispersi-
on media may cause small fluctuations in the speed of the device.

Commissioning

Pay attention to the ambient conditions listed in the "Technical Data".
Position the rotating knob (B) at the
left stop before starting up.
If these conditions are met, the unit
is ready for service when the mains
plug has been plugged in.
Switching on
Press "Power" button (A)
Previous mode and time
settings will be displayed e.g.
(Factory setting: -2)
Setting Timer (Changing of modi)
Switch of the device
Minutes-mode
Press and hold "Start/STOP" button (C),
and also press the "Power" button (A)
Minutes-mode display
The time that was previously
set will be stored, e.g.
Note: max. 29 min., speed range upto 4000 min
10
All manuals and user guides at all-guides.com
Seconds-mode
Press and hold button "Start/Stop" (C)
and also press the "Power" button (A).
Seconds-mode display
The time that was previously
set will be stored, e.g.
Note: max. 59 sec, speed range upto 6000 min
Setting the time
The value that was previously
4
5
3 6 set will be stored, e.g.
2 7
(Factory setting: 00)
8
1
9
0
- 2 2 7
Set the tens digit
using button (E)
Attaching the tube
Fit the tube carefully and en-
sure it is properly attached.
Power
Setting the speed
Set the desired speed in the range of 300 - 6000 min
using the infinitely adjustable rarotary knob (B)
Start
Power
Stop
- 1
Starting
Press "Start/Stop" button (C),
3 2
While the preset countdown is running,
timer display will blink
An audible signal will be given when the
-1.
countdown is complete
Power
- 2
2 7
-1
2 7
2 7
10 1
Set the ones digit
using button (D)
4
-1
3
2
1
0
0 5
Start
Stop
5
6
7
8
9
Start
Stop
032007