Switching On | Self-Check | Send Mode; Group Check - Black Diamond Guide BT Bedienungsanleitung

4.3 SWITCHING ON | SELF-CHECK | SEND MODE

Switching on: Move the slider lock (1C) to the left and the slider (1B) upwards into the position SEARCH. Then
release the slider lock (1C) and move the slider (1B) downwards, until it locks in the position SEND.
The display shows firmware version, battery capacity, self-check progress (4A), self-check result (4B), group check
countdown (4C) and finally the send display with the active transmitting antenna (4D).
The device is now in send mode, the transmit control LED (1G) is blinking.
NOTICE A minimum distance of 5 m from other devices and all electronic, magnetic and metallic sources
of interference should be kept during the self-check.
DANGER Always physically verify that the switch is securely locked into position. The Slider should not
move unless the Slider Lock is dis-engaged.
If the self-check is successful, "OK" is indicated on the display (4B). In the event of a device warning, an alert signal
sounds and the display indicates "E" in combination with a number (4E). For error codes, see chapter 6.1.
4A
Firmware version
Battery capacity/type
(AL=Alkaline,
LI=Lithium)
Send-Vibra
Additionally, the GUIDE BT provides haptic send mode confirmation (10x vibration).
This feature is enabled by default and can be disabled in the PIEPS APP device manager.
Manual BLACK DIAMOND GUIDE BT/RECON BT
4B 4C
Self-check OK

Group check

countdown
4D 4E
SEND display Self-check error
10 / 25