Operating The Machine; Control Icons - HOLZMANN-MASCHINEN ED1000FB Betriebsanleitung

10. Move the spindle speed selector lever (H) to position "L" so that the headstock is set to
the lower speed range (70-440 min
to engage the lever.)
11. Connect the machine to the power source and then turn the main power switch to the ON
position.
12. Press the shift lever rotating direction (S) to start the machine. The spindle rotates at
70 min -1 . When correctly operated, the machine runs smoothly with little or no vibration or
friction.
13. Move the shift lever rotating direction (S) to the center position and press the Emergency
Stop button (I).
14. Without resetting the Emergency Stop button (I), move the shift lever rotating direction
(S) down. The machine must not start.
15. If this is the case, the safety function of the Emergency Stop button (I) is guaranteed.
Continue with the next step.
16. However, if the machine starts with the Emergency Stop button (I) pressed in, disconnect
the power supply to the machine immediately. The Emergency Stop button (I) does not
function properly. In this case contact the customer service.
17. Turn the Emergency Stop button (I) clockwise until it pops out.
18. Make sure that the power indicator light (D) is working.
19. Make sure that the coolant nozzle is pointing towards the chip tray, then turn the coolant
pump switch and open the nozzle valve. After checking that the coolant is flowing out of
the nozzle, turn off the coolant switch.
20. Start the spindle and then apply the foot brake. The power supply to the motor should be
interrupted and the spindle should stop immediately.
The retraction must be carried out at the lowest spindle speed. Let the machine run at this speed
for about 1 hour. Pay attention to any abnormalities and/or irregularities, such as unusual noises,
unbalance, etc. If everything is O
reached after 10 hours of operation.
If unusual noises or vibrations occur during the test run, stop the machine immediately and read
the Troubleshooting section. If you cannot find a remedy, contact your specialty retailer or
customer service.
18.3

Operating the machine

18.3.1 Control icons

HOLZMANN MASCHINEN GmbH
-1 ). (You may need to turn the chuck slightly by hand
, gradually increase the speed. The highest speeds may only be
K
Main switch
I: ON
0: OFF
Half nut opened
Metric thread
Right-hand thread and
longitudinal feed to the headstock
side (left illustration)
www.holzmann-maschinen.at
OPERATION
Coolant
Green: On
Red : Off
Half nut closed
Imperial thread
Left-hand thread and
longitudinal feed to tailstock
side (right picture)
ED1000FB| ED1000FBDIG
62