Tips For Use; Maintenance - Greencut MH202-4 Betriebsanleitung

56
ATTACHMENT/REMOVAL OF THE SANDING SHEET
The triangular sanding plate is fitted with a Velcro fastener for quick attachment of the sanding sheet.
1. Press the sanding sheet evenly onto the delta sanding plate. Make sure that the holes in the sanding sheet
are located above the openings in the sanding plate.
2. To remove the sheet simply pull the sanding sheet out of the delta sanding plate.

TIPS FOR USE

SAWING
• Only use saw blades that are in perfect condition. Use only metal saw blades for working metal.
• Make sure your posture is stable and hold the saw firmly with both hands and away from your body.
• Before sawing the workpiece, check for hidden foreign objects such as nails or screws. These must be removed.
• Plunge cuts can only be made in soft materials such as wood or plasterboard.
SAND
• Use a dust extraction system when sanding with the multi-sanding attachment.
• Place the tool against the workpiece once it is switched on.
• Clean the sanding plate before inserting a sanding sheet.
• Work only with sanding sheets in perfect condition to achieve good sanding results.
• Work with low and even pressure. This protects the machine and the sanding sheet.
• Do not use the same sanding sheet for sanding different materials (e.g. metal and then wood).
• Selection of the sanding sheet, Particle size P:
-P 60 for pre-sanding rough wood surfaces
-P 80 / 120 for smooth sanding
-P 240 for fine sanding of primed and painted surfaces
TO SCRAPE
• Use a high oscillation rate when scraping.
• Work with low pressure and at a low angle to avoid damaging the substrate material.

MAINTENANCE

Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the machine is completely turned off before performing any maintenance
or repairs. This will eliminate any potential risk.
The machine is set at the factory. Do not make unnecessary adjustments, adjust only when necessary
due to normal wear.
• Do not spray the appliance with water or immerse it in water. Danger of electric shock.
• Keep the ventilation slots, motor housing and handles of the appliance clean. Use a damp cloth or brush.
• Do not use cleaning agents or solvents. Do not use cleaning agents or solvents, otherwise the appliance may be
irreparably damaged.