BRAYER BR2330 Bedienungsanleitung Seite 4

4 EN
SAFETY MEASURES AND OPERATION
RECOMMENDATIONS
Read the operation manual carefully before using
the nut maker; after reading, keep it for future
reference.
• Use the unit for its intended purpose only, as it is
stated in this manual.
• Mishandling the unit can lead to its breakage and
cause harm to the user or damage to the user's
property, which is not covered by warranty.
• Make sure that the operating voltage of the unit
indicated on the label corresponds to your home
mains voltage.
• Connect the power plug to the socket with reliable
grounding contact. In case of short circuit the
grounding reduces the risk of electric shock.
• Contact an electrical technician, if you are not
sure that your sockets are installed properly and
grounded.
• Do not connect the unit to external timers or remote
control mains sockets.
• To avoid fire, do not use adapters for plugging the
w in.
• Install and use the nut maker on a flat, dry, steady
and heat-resistant surface with free access to the
mains socket.
• Use the unit in a well-ventilated room, for normal
air circulation the free space around the nut maker
should be at least 10-15 cm on each side.
• During the nut maker operation do not allow the unit
body to come in contact with curtains, wall coverings,
clothing, kitchen towels or other flammable materials.
• Do not use the unit outdoors.
• It is recommended not to use the unit during lightning
storms.
• Protect the nut maker from impacts, falling, vibrations
and other mechanical stress.
• Never leave the unit connected to the mains
unattended.
• Do not use the unit near heating appliances, heat
sources or open flame.
• Do not use the nut maker in places where aerosols
are used or sprayed, and in proximity to inflammable
liquids.
• Do not use the nut maker in proximity to the kitchen
sink, in bathrooms, near swimming pools or other
containers filled with water.
• If the nut maker is dropped into water, unplug it
immediately, and only then you can take the unit
out of water. The unit body heats up strongly during
operation, be careful and do not touch its hot
surfaces.
• Do not let the power cord touch hot surfaces and
sharp edges of furniture.
• Do not move the nut maker when it is hot; wait until it
cools down completely.