Insertion Of Batteries; Device Description - LaserLiner ActiveFinder Bedienungsanleitung

Safety instructions
Using artificial, optical emission (OStrV)
LED outlet
(see Fig. A)
– The device works with LEDs of risk group RG 0 (exempt, no risk) in accor-
dance with the latest versions of applicable standards relating to photo-
biological safety (EN 62471:2008-09ff / IEC/TR 62471:2006-07ff).
– Radiation power: Peak wavelength equals 456 nm. Mean radiance is below
the limit values of risk group RG 0.
– When used for the intended purpose and under reasonably foreseeable condi-
tions, the accessible radiation of the LEDs is safe for the human eye and skin.
Safety instructions
Dealing with electromagnetic radiation and electromagnetic disruptions
– The measuring device complies with electromagnetic compatibility
regulations and limit values in accordance with EMC-Directive 2014/30/EU.
– The measuring device complies with safety and electromagnetic compatibility
regulations and limit values in accordance with Directive 2014/35/EU
(Low Voltage Directive / LVD) and 2014/30/EU (Electromagnetic Compatibility
Directive / EMC).
– Umarex GmbH & Co. KG hereby declares that the ActiveFinder complies with
the essential requirements and other provisions of the European Low Voltage
Directive 2014/35/EU (LVD) and the Electromagnetic Compatibility Directive
2014/30/EU. The EU Declaration of Conformity can be found in its entirety at
the following address: http://laserliner.com/info?an=AAB
– Local operating restrictions – for example, in hospitals, aircraft, petrol
stations or in the vicinity of people with pacemakers – may apply.
Electronic devices can potentially cause hazards or interference or be subject
to hazards or interference.
Symbols
Fig. B: Warning about hazardous electrical voltage: Unprotected live compo-
nents inside the device housing are capable of posing a risk of electric shock.
Fig. C: Protection class II: The test device has reinforced or double insulation.
Fig. D: Overvoltage category III: Equipment in fixed installations and for
applications where specific requirements with regard to the reliability and
availability of equipment have to be met, e.g. circuit-breakers in fixed
installations and devices used in industrial applications which are permanently
connected to the fixed installation.
1

Insertion of batteries

Open the battery compartment and insert batteries according to the symbols.
Be sure to pay attention to polarity.
!
The device is ready for use immediately once the batteries have been
inserted. It does not have a separate ON/OFF switch and is therefore
always active.

Device description

1 Detector tip
2
ZOOM function
ON/OFF
Before using the device, you should always test it on a main circuit you
!
know to be operational within the specified voltage range. To avoid
inaccurate measurements, check the device batteries prior to use by
switching on the built-in battery lamp. (see Fig. A)
06
EN
(see Fig. E)
(see Fig. F)
3 Pocket clip
4
Battery lamp
ON/OFF
5 Battery lamp
6
Battery compart-
ment on the rear
of the device