Door Reversibility - Zanussi ZFU27401WA Benutzerinformation

Door reversibility

WARNING!
Before carrying out any operations,
remove the plug from the power
socket.
1. Tilt back the appliance carefully so that the
compressor cannot touch the floor.
2. Remove the plinth.
3. Unscrew and remove the lower hinges.
4. Remove the door.
5. Unscrew the upper pin and screw it on the
opposite side.
2
1
6. Refit the door.
Make sure the edge of the door is parallel
with the edge of the top.
7. Unscrew the pin (A) and screw it on the
opposite side.
26
All manuals and user guides at all-guides.com
8. Remove the cap (B) and position it on the
9. Screw the lower hinges.
10. Refit the plinth.
11. Stand the appliance upright.
12. Fit the handle on the opposite side and put
A
B
opposite side.
the plastic caps (contained in the
instructions bag) in the free holes.
CAUTION!
Reposition, level the appliance, wait
for at least four hours and then
connect it to the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The magnetic seal adheres to the
cabinet.
• The door opens and closes
correctly.
If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case,
wait for the natural fitting of the
gasket. In case you do not want to
carry out the above mentioned
operations, contact the nearest After
Sales Service Force. The After Sales
Service specialist will carry out the
reversibility of the doors at your cost.
www.zanussi.com