Additional Information On Soldering; Wood Burning Pen; Storage Conditions - Parkside PLBS 30 B2 Bedienungs- Und Sicherheitshinweise

occasionally with the cleaning sponge (2) and re-tin the tip if necessary. Use a de-
soldering braid (not supplied) to clean the joint, to de-solder and to remove excess
solder from the joint. Cover the excess solder with the de-soldering braid and heat up the
soldering tip (9). The melted solder is soaked up by the de-soldering braid.

Additional information on soldering

Solder and flux
Solder for the DIY market is almost exclusively produced in the form of wire.
There are two types of solder wire on the market:
1. Simple, unfilled solder wire - additional use of a suitable flux is required.
2. Solder wire with flux core.

Wood burning pen

• Firstly, make a sketch of the desired pattern on your workpiece with a pencil or
alternatively apply a ready-made template to the workpiece.
• Types of wood with smooth surfaces are particularly suitable for burning.
• When burning wood with a rough surface, be aware that it can be difficult to guide the tip
along the line required. In this case the surface should be sanded first.
• A wide variety of patterns can be created with the marking tips supplied.
• A sooty deposit can build up on the tip or the stamp during use. Use fine sandpaper to
remove the deposits and to keep the tips clean. A clean tip is essential for precise and
accurate work.

Storage conditions

• If the soldering iron set is not to be used keep it at a safe, cool, dry and well-ventilated
place out of the reach of children.
• Allow the appliance to cool down completely before storage.
56