mysoda TOBY Bedienungsanleitung Seite 7

INSTALLING THE CO2 CYLINDER
NOTE: The device can use 60 litre and 130 litre CO2 cylinders. 130 litre cylinders are available on a
limited basis and only in certain countries.
1. Remove the water bottle 2. Uninstall the top part of
by pulling the bottle and the device body by turning
carbonation nozzle towards it anti-clockwise.
yourself, and then unscrew it
(one quarter clockwise).
Installing 60L CO2 cylinder:
5a. Install the CO2 cylinder by
screwing it clockwise. Attach the
cylinder firmly enough, but do not
tighten too much.
Installing 130L CO2 cylinder:
1
5b. Carefully insert the top part to
the bottom part. Turn the top part
clockwise until it clicks into place.
1
2
3. Unscrew the black
thread protective cap on
the top part of the device
body.
1
6a. Carefully insert the CO2 cylinder
and top part together to the bottom
part. Turn the top part clockwise until
it clicks into place.
2
6b. If you are using a 130 litre CO2 cylinder, turn over the adapter on the
bottom of the unit, so that you can install a larger cylinder.
4. Remove the seal and cap
from the CO2 cylinder.
CHANGING THE
CO2 CYLINDER:
2
After the CO2 cylinder is
empty, replace the CO2
cylinder in the same way as
the first time you installed
the cylinder.
EN
7