Electronic Controller; Knowing Your Danfoss Erc-112 Controller; Door Blocking System; Application With Hinged Door Icms - FRIGOGLASS MAX-450 C Benutzerhandbuch

4. Electronic controller*

4.1

Knowing your Danfoss ERC-112 Controller

For instructions of the functionality of Danfoss ERC-112 Controller and its related optional features,
please visit the following website link: http://www.frigoglass.com/manuals/.

5. Door blocking system*

In using the door blocking system, please follow the steps below
5.1

Application with hinged door ICMs

To block the Door at 90 degree:
Step 1: Open the door to an angle slightly greater than 90 degrees
Step 2: Remove the door blocker from bracket below the door (as shown in the picture)
Step 3: Rotate the door blocker towards the cabin and insert it in bracket located at front grid (as
shown in the picture)
To unblock the Door:
Step 1: Open the door slightly greater than 90 degrees and remove the door blocker manually from
bracket located at front grid
Step 2: Rotate the door blocker towards door and snap fit in bracket below the door (Initial position)
5.2

Application with sliding door ICMs

Step 1: Open the left door (same procedure also for right door)
Step 2: Lift up and rotate the door blocker towards the cabin (as shown in the picture)
Step 3: Place door blocker vertical to door guides (as shown in the picture). Door blocker will be
blocked at door guides walls and prevent the door to close.
Step 4: Release the door blocker from the stopping point and rotate to the initial position
*optional feature
Automatic removal of door blocker from bracket located at front grid is
for accidental purpose only.
ENG
14