Samsung HW-S50A Bedienungsanleitung Seite 13

 (Sound Control)
By pressing the button, you can select the desired audio mode. The desired settings can be adjusted
using the Up/Down buttons. Each time the mode changes, the Multicolour LED blinks in white.
LED
Indicator
– To control the volume of the treble or bass sound, select "Treble", "Bass", "Sync", or "Centre Level" in
Sound Settings, and then adjust the volume between -6~+6 by using the Up/Down buttons.
7 Band EQ
Press and hold the
frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/
Right buttons and each can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to "Standard".)
Press and hold the
for about 5 seconds.
– To control the volume of the each speaker select "Centre Level" in Sound Settings, and then adjust
the volume between -6~+6 by using the Up/Down buttons.
– If the video on the TV and audio from the Soundbar are not synchronised, select "Sync" in Sound
Control, and then set the audio delay between 0~300 milliseconds by using the Up/Down buttons.
(Not available in "USB" or "Bluetooth"mode.)
– "Sync" is only supported for some functions.
White Blinks X1
"Treble"  "Bass"  "Sync"
(Sound Control) button for about 5 seconds to adjust the sound for each
5 Sec
(Sound Control) button
"150Hz"
PAIR
SOUND
MODE
VOL WOOFER
 "Centre Level"
7 Band EQ
Using the Left/Right buttos and each can be
adjusted to setting between -6 to+6.
"150Hz"
ENG - 13
 
"300Hz" "600Hz"
"2.5kHz"  "5kHz"  "10kHz"
 
"1.2kHz"