Operation - Adler europe AD 7966 Bedienungsanweisung

fall to the floor and cause moisture.
37. Do not lift the water tank by the water mist outlet.
38. It is prohibited to insert metal chips, wire, needles and other foreign objects into the
product or into the housing gaps, otherwise it may cause electric shock or malfunction.
39. Be aware that high humidity levels may encourage the growth of biological organisms
and fungi in the environment.
40. Too much humidity in the room can lead to moisture accumulation causing the damage
to walls, furniture, wallpaper and electric other appliances as TV. Do not direct the mist
outlet close to such objects.
41. Do not permit the area around the humidifier to become damp or wet. If dampness
occurs, turn down the mist production. If the mist capacity cannot be turned down, use the
humidifier intermittently. Do not allow absorbent materials, such as carpeting, curtains,
drapes, or tablecloths, to become damp.
42. Do not cover the device. Do not place any objects on the top of the device.
43. Do not use the device in association with a programmer, timer or other device that
automatically switches the humidifier on.
The device is designed to work in rooms with a temperature of 5-40°C and a relative humidity below 80%.
Device description: Humidifier AD7966
1. Cover
3. Water tank 4,6 liters
4A. Power button
4C. Timer button
4F. Humidify button
5. Aromatherapy oil box
7. Water level control module
9. Atomizer
11. Water shortage indicator

OPERATION

1.Stand up the device on stable, flat surface. Remove the water tank (3) from the water basin (6) to take away the protection foam
located under the water level control module (7).
2.Make sure the descaling filter (10) (grey ring attached in set) is lay on the atomizer (9).
3.Fill the water according to instruction in chapter: Filling the water.
4.Plug in the device.
5.Press the POWER button (4A), the LCD screen (4G) lights up and the device starts to work with high mist. Press again to turn off the
device.
6.Press the HYGROSTAT button (4B) to select the desired level of humidity. The default humidity is 40%, it can be increased by 5% until
90% by repeated pressing the HYGROSTAT button (4B), the device will stop working when the room humidity reaches desired humidity
value.
7.Press the TIMER button (4C) repeatedly to adjust the working time from 1 hour to 12 hours in one-hour increments. The device will
2. Mist outlet
4. Control panel
4B. Hygrostat button
4D. Sleep button
4G. LCD display
6. Bottom water basin
8. Water shortage sensor
10. Descaling filter
6