Fronius TTB 80 G Bedienungsanleitung Seite 75

1
Connect the welding torch to the interconnecting hosepack
Fit the protective bag:
Position the protective bag as follows:
2
- the Fronius logo must be visible
- the loops of the protective bag must be at the top
Notes on the following diagrams:
left = power source end (A)
right = welding torch end (B)
Open the protective bag:
3
- Push both zip pulls to the right as far as they will go
- Pull the bottom end of the tape out of the zip pulls
Place the interface connecting the extension hosepack and the torch hosepack in
4
the inside pocket of the protective bag
5
A
- * = Velcro strips on the inside pocket (inside pocket not shown)
- Secure the interface in the inside pocket with 2 Velcro strips
1
3
2
2x
B
75