EUROM AC2401 Bedienungsanleitung Seite 21

Cool setting
1. Press the Cool button (Figure 12, pos. 1)
repeatedly to set the required ambient
temperature:
•
28 °C, the display will show 1 cool indicator
(Figure 12, pos. 4).
•
25 °C, the display will show 2 cool indicators
(Figure 12, pos. 3).
•
22 °C, the display will show 3 cool indicators
(Figure 12, pos. 2).
•
<22 °C, the display will show 6 cool indicators
(Figure 12, pos. 2, 3 and 4).
Timer
At the end of the set countdown timer the device will automatically switch off.
1. Press the Timer button (Figure 13, pos. 1)
repeatedly to start the countdown timer of:
•
0.5 hour: the 0.5 hr indicator (Figure 13, pos.
2) will light up;
•
1 hour: the 1 hr indicator (Figure 13, pos. 3)
will light up;
•
2 hours: the 2 hr indicator (Figure 13, pos. 4)
will light up;
•
4 hours: the 4 hr indicator (Figure 13, pos. 5)
will light up;
•
7.5 hours: the 0.5 hr indicator, the 1 hr
indicator, the 2 hr indicator and the 4 hr
indicator (Figure 13, pos. 2, 3, 4 and 5) will
light up.
Drainage of condensed water
Automatic
As soon as the condensate in the collecting tray of the indoor part has reached a certain
height (0.8 liter), the pump automatically leads it to the condenser in the outdoor part. In the
outdoor unit, the water is partially evaporated with the discharge of the warm air. The
remaining water is drained through the drain pipe at the bottom of the outdoor unit.
Manual
In the event of a malfunction of the automatic drainage, you will hear an alarm for 20 seconds
and the device will switch off. The water has to be removed manually.
1. Remove the plug at the bottom of the indoor unit.
2. Connect the supplied drain hose to the bottom of the indoor unit.
3. Turn the device back on. The device can be used in this way temporarily even with a
defective pump.
Figure 12
Figure 13
21