All manuals and user guides at all-guides.com
p. Do not move or bump Dremel 3D40 or the
extruder during operation. The object may build
incorrectly.
q. Do not change colour of filament or spool
during building. Doing so will cancel the object
and may damage the extruder.
r.
Do not pull the filament out until instructed
by the touch screen. Doing so may damage the
extruder.
s. Use extra care not to damage the extruder tip
when clearing debris. Dremel 3D40 will not work
properly with damaged extruder tip and will require
replacement.
Before every build make sure that the build
platform is covered with Dremel specified build
tape. Use of improper build tape may result in
equipment damage and poor object build quality.
u. Be aware of your body position when using
hand tools to remove objects from the build
platform. Sudden tool slip and improper body
position during object removal from the build
platform may result in personal injury.
v. Avoid scratching the build platform when
removing objects. Scratches in the build platform
w. Do not drop the build platform. Tempered glass
plate may break and result in personal injury.
x. Do not remove tempered glass plate from
plastic holder. Contact with tempered glass plate
edge may result in personal injury.
y. Do not twist or bend the build platform while
removing objects. Tempered glass plate may
separate from plastic holder and result in personal
injury.
z. Dremel is not responsible for structural integrity
or utility of objects created using Dremel
3D40. Structural models created by inexperienced
designers may result in property damage and
personal injury.
SERVICE
a. Always unplug Dremel 3D40 from its power
before performing any service procedures.
Failure to do so may result in personal injury and
equipment damage.
b. Have your Dremel 3D40 serviced only by an
authorized Dremel service centre using only
Dremel replacement parts. This will ensure that
proper operation and safety of Dremel 3D40 is
maintained.
c. Use only Dremel approved materials and
components. Use of object materials, or 3D
objects other than Dremel
approved object
®
materials and genuine Dremel
void warranty.
Used symbols ....................................................357
Introduction ........................................................362
Kit Contents*......................................................362
Touch Screen .....................................................364
Initial Setup ........................................................370
Building ..............................................................375
Maintenance .......................................................379
Warranty .............................................................383
components may
®
356
TABLE OF CONTENTS
Symbo
WARNIN
!
WA
!
PRODUCT
WHICH CA
TAKE ADE
INFO
The Drem
from digita
right to pr
objects us
to ensure
intellectua
laws or re
property la
make obje
owned by
permission
following m
to make a
any objec
a digital fi
a scan of
your respo
cases, you
Where su
should no
own risk.
decompile
software o
law. If you
as recomm
Safety Ins
the Dreme
intellectua
result in c
and you c
imprisonm