Technical Data - Beper 70.239A Betriebsanleitung

Tower Fan Use instructions
USE
Check that the switch on/off (1) is OFF, that the speed selector (2) is not selected. Insert the cord
supply (7) into the socket.
Place the fan tower on a stable surface.
To switch on the fan tower switch on/off (1) ON and choose the desired speed with the speed se-
lector (2).
Selecting 0 the fan tower is OFF.
Selecting 1 low speed.
Selecting 2 medium speed.
Selecting 3 high speed.
To switch off the fan tower press the speed selector on speed 0 and the switch on/off (1) OFF.
AIRFLOW DIRECTION
It is possible to change the airflow direction in 5 gradual direction by lightly pressing with hand on
the right or on the left, until hearing a « click ».
SWING 90° HORIZONTAL FUNCTION
To activate the fan tower swing 90° horizontal press switch on/off swing (3) and start swing.
To disconnect the swing, press again the switch on/off swing (3)
FONCTION TIMER
Choose the desired time with the switch timer (1), the fan tower will automatically switch off when
selected time finished.
If timer function is not used, press switch on/off (1) ON. If the switch (1) is OFF, the fan tower is not
working, even if speed is selected (by switch 2).
CLEANING
Before cleaning, switch off the fan tower and unplug from the socket.
For cleaning the fan tower use a soft cloth, eventually lightly wet with water.
Do not clean the airflow exit grid with the vacuum cleaner, in case of hard dirt, use a brush.
Do not use alcohol or chemical substances such as thinners, abrasive detergent in general.
Do not spray water or other liquids directly on the fan tower ; do not introduce liquids into the grid.
Dry every cleaned parts before switch on again the fan tower.

TECHNICAL DATA

Power 45 W
Power supply 230V ~ 50Hz
For any improvement reasons, Beper reserves the right to modify or improve the product
without any notice.
11