Storage Of The Device - Fuxtec FX-MHP245 Original Bedienungsanleitung

3. Wet metal parts with anti-rust oil and place the protective cover on the cutting edge.
4. Store the device in a place protected from moisture for storage.

23. Storage of the device

WARNING: If you do not follow these steps, deposits may form in the
carburettor. This makes it difficult to start later and causes permanent
damage.
1. Performing all general maintenance as described in the maintenance section of your
user manual are recommended.
2. Clean the exterior of the device, drive axle, protective shield and nylon cutting head.
3. Drain fuel from the fuel tank.
4. After the fuel is drained, start the device.
5. Have the device idling until the device stops by itself. This will clean the carburettor of
fuel.
6. Let the device cool down (about 5 minutes).
7. Using a spark plug wrench, remove the spark plug.
8. Pour 1 teaspoon of clean 2-stroke oil into the combustion chamber. Pull the starter
cord
Slowly several times to coat internal components. Replace the spark plug.
9. Store the device in a cool, dry place away from any ignition source such as an oil
burner, water heater, etc.
TRANSPORT SAFETY
Make sure that the device is well secured during transport to avoid fuel loss, damage or
injury. Install a transport protection system of metal sheets during transport and
storage.
Original User Manual FUXTEC FX-MHP245_de_en_fr_ita_rev1
52