Troubleshooting - BGS technic 3206 Bedienungsanleitung

Storage
Contamination caused by dust or dirt can affect the gun's efficiency. Wrap up the spray gun with a
piece of plastic or kitchen foil before you store it so that it is secured against any type contamination
and later damage.
Maintenance / Cleaning
The spray gun does only work properly when it is kept clean. Clean your spray gun carefully and
thoroughly after each use. Follow these steps:
•
Clean your tool by using paint thinner. Run the gun with paint thinner instead of paint to clean its
interiors.
•
The nozzle thread and all moving parts should be lubricated with acid-free oil.
•
Never use hydrocarbon halogen solvents to clean the gun. This may cause a chemical reaction.
•
Never dip the gun completely into paint thinner.
CAUTION
Disconnect the spray gun from its air supply before maintenance or cleaning!
LUBRICATION & MAINTENACE
Only operate with compressed air systems that have the correct air pressure and sufficient air volume
(L / min) for this tool.
Drain the compressed air system before each use.
Water in the compressed air line leads to tool destruction and loss of performance.
Clean or replace air filters at the specified intervals.

TROUBLESHOOTING

Error
Too little or no pressure in
the tool
No air in the tool
Unsteady spray jet
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Possible cause
The pressure reducer has not
been opened
The air hose leaks
The nozzle is jammed
The air supply is being blocked
The paint has not been
thinned enough
Too little paint in the cup
Too high or too low operating
pressure
Dirt and/or residual paint block
the nozzle
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
Help
Check the pressure reducer's setting
– open it if necessary
check all connections and seal
leaking components if necessary
Clean lean the nozzle and remove
residual paint/varnish
Check the air supply and the setting
of the pressure reducer – open it if
necessary
Thin down the paint according to its
manufacturer's recommendation
Fill up the cup with paint (watch its
min./max. capacity)
Adjust the operating pressure with
the pressure reducer
clean the nozzle and/or replace it if
necessary
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed