Laserworld CS-2000 RGB NET Bedienungsanleitung Seite 8

Manual: Club Series CS-2000RGB NET
DMX settings
193-255 Automatic size change of Y axis with increasing speed
5 0-192
193-255 Automatic position change of X axis with increasing speed
6 0-192
193-255 Automatic position change of Y axis with increasing speed
7 0-192
193-255 Automatic rotation with increasing speed
8 0-192
193-255 Automatic blanking with increasing speed
9 0-192
193-255 Automatic blankshift with increasing speed
10 0-15
16-31
32-47
48-63
64-79
channel range
10 80-95
96-111
112-127 Pattern completely white
128-255 Rainbow effect
11 0-31
32-255
Connect a DMX controller to operate the laser.
Your device runs in the Micro SD Card mode:
7.
Dip switch setting
switch 1
On (1) / Off (0) 0
In the SD card mode, the ILDA interface plays the laser show files stored on a microSD card in
an endless loop.
page 8 / 22
Position of the laser projection X axis
Position of the laser projection Y axis
Rotation of the laser projection
Blanking: selects how much of the laser pattern shall be blanked
Blankshift: selects which part of the laser projection shall be blanked (use only
in combination with channel 7 - blanking)
Show pattern in original colors
Pattern completely red
Pattern completely green
Pattern completely blue
Pattern completely yellow
function
Pattern completely magenta
Pattern completely cyan
Default scan speed (200 points per second)
Manual selection of scanspeed (5000 - 30000 points per second)
Attention: make sure not to overload the scanners of the laser projector! If
you're unsure about the maximum scanspeed of your laser projector, stay with
the default setting.
2 3 4
0 0 0
5 6 7
0 1 0
8 9 10
1 0 0