Settings; Operation And Operational States; Led Indicators - Stahl ispac 9192 Betriebsanleitung

english

Settings

RS-485 address
5
1's position
1
5
10's position
5
100's position
1 0 0
Example (see Fig.): Address 103
8

Operation and operational states

Before commissioning the device, please ensure that:
•
the device has been installed in the correct slot and in accordance with the standards
•
the device is not damaged
•
the cables are properly connected

8.1 LED indicators

Description Colour Display
PWR Green Continuously lit green supply voltage OK
HART-Tx
Yellow Lights alternately: communication with HART field devices OK.
HART-Rx
RS485-Rx
Yellow Lights alternately: communication with PC via RS 485 interface OK.
RS485-Tx
Operating Instructions
Number of channels / transfer rate
16 channels
9,6 kBit/s
19,2 kBit/s
38,4 kBit/s
57,6 kBit/s
Example (see figure): 16 channels, 9,600
bit/s
)* These settings should be selected for the
operation with PRM, if Remote I/O IS1 from
R. STAHL is connected to the same Bus
setting "9k6 A" should be selected.
Note: The setting only becomes effective
after a software reset or a device reboot.
HART Multiplexer Type 9192
32 channels
19,2 kBit/s )*
9,6 kBit/s
19,2 kBit/s
38,4 kBit/s
57,6 kBit/s
9,6 kBit/s )*
17