Initial Installation; Network Configuration - AEG IR 4436 Bedienungsanleitung, Garantie

English
38

Initial installation

NOTE:
Your router must be configured so that it allows new WLAN devices to be con-
nected.
After switching on the device, you will be asked to select the OSD language.
1. Using the Navigation buttons / , select an OSD language. Confirm your selec-
tion with SELECT.
2. Now select whether the network should be checked when switching on the
devices. Make your selection with the Navigation buttons / . Confirm your
selection with SELECT.
NOTE:
This setting can be changed again afterwards in the menu.
3. Now you will be asked whether you want to configure the network now. Using
the Navigation buttons / , select "Yes" and press SELECT. The device will now
search for available WLAN networks.
4. Using the Navigation buttons / , select your network and press SELECT.
5. With the help of the Navigation buttons, now enter the password (WPA key) for
the access point which you have stored in your router or network switch. Then,
press SELECT. The device is now connected to your router.
NOTE:
• The symbol shows you that a connection has been established to your router.
The bars next to the symbol show the signal strength of the connected router. If
there is interference on the internet radio reception, please change the location
of the Internet radio.
• The symbol shows that there is no connection to your router.

Network Configuration

In the "Configuration/Network" menu, the following WLAN settings are available:
Wireless Network Configuration, Wireless Network (WPS PBC), Manual Configura-
tion, Check Network when Power On.
• Press the MENU button to call up the menu.
• Select item "Configuration" and then "Network".