Oled Display - Cameo CLPFLATPRO7G2 Bedienungsanleitung

DMX IN
3
Male IP65 3-pin XLR socket for connection to a DMX control device (e.g. DMX console) When not
in use, always close with the appropriate rubber sealing cap.
DMX OUT
4
Female IP65 3-pin XLR socket for sending the DMX control signal. When not in use, always close
with the appropriate rubber sealing cap.
FUSE
5
IP65 fuse holder for 5 x 20 mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the
same type and of the same value (see stamp on back of device). In the event of repeated fuse
failure, please contact an authorised service centre.
PRESSURE EQUALISATION ELEMENT
6
The pressure equalisation element serves to prevent condensation inside the housing. In order to
ensure its proper function, the element must be protected from contamination.

OLED DISPLAY

7
The OLED display shows the currently activated mode (main display), the menu items in the
selection menu and the numerical value or operating mode in certain menu items. If there is no
input for approx. 30 seconds, the display automatically returns to the main display. Note regar-
ding the main display in operating modes with external control: As soon as the control signal
is interrupted, the characters in the display begin to flash. When there is a control signal again,
the flashing stops. Briefly pressing UP on the control panel when in the main display rotates the
display by 180°.
ILLUMINATED CONTROL PANELS
8
Illumination of the control panels is activated as soon as one of the capacitive control panels is
touched; only then is operation via control panels possible. If no input is made within approx. 30
seconds, the control panel illumination goes off.
MENU – Press MENU to access the selection menu. Press repeatedly to return to the main display.
Pressing MENU without confirming a value or status change with ENTER restores the previously
confirmed value or status.
ENTER – Press ENTER to access the menu levels to make value changes and use the ENTER control
field to access the submenus. Confirm value or status changes by pressing ENTER.
UP and DOWN – Select individual menu items in the selection menu (DMX address, operating
mode etc.) and in the submenus.
Allow changes to the value in a menu item, such as the DMX address, as required.
11