Profile ESD-1 Bedienungsanleitung Seite 74

Press the ▲ button to increase the value by 0.01
Press the ▼ button to decrease the value by 0.01
(the limit for the pollution setting is: 0.10 – 2.55 kWh)
If you wish to change these settings quicker, press and hold the key for more than
1 second to allow you to alter the settings by 8 instead of 1 each press.
Press SET key once will save the setting and return to INSTANT mode.
Note: If there is no key pressed within 10 seconds or the MODE key is pressed,
the unit will return to INSTANT mode without saving.
-- CLEAR Data mode
Once entering the Clear Data mode, "CLEAR" icon appears on the LCD and will
flash.
Press SELECT key once and the screen will show a "CONF" icon (please note
that you need to confirm the operation).
If you want to confirm the operation, press and hold the MODE key, then the unit
will send a "beep" sound, all the data will be cleared. The system will
automatically exit and go back to the INSTANT mode.
Otherwise press the SELECT key to exit the confirm mode and go back to the
instant mode without any change.
Tarrif Function
In Instant mode, press & hold MODE button for 2 seconds, the Remote Display Unit will
enter the TARIFF SETTING mode, the tariff & 1 (or 2) icon will flash.
Press ▲ or ▼ key to select the Single or Dual Tariff Mode
Press SELECT key to confirm the selected tariff mode.
Note: If there is no key pressed within 10 seconds or the MODE key is pressed,
the unit will return to INSTANT mode without saving.
If Single Tariff Mode (Tariff 1) is selected, the unit will turn back to the instant mode
automatically (because Tariff 1 mode has been set in the Tariff 1 Cost Setting section).
If Dual Tariff Mode (Tariff 2) is selected, the user will be required to input more
parameters as follows:
Tariff 2 Start Time  Tariff 2 End Time  Tariff 2 Cost
All manuals and user guides at all-guides.com