Troubleshooting Guide - Braun CareStyle 5 Bedienungsanleitung

Trouble shooting guide
PROBLEM
The appliance does not switch on.
Steam comes out under the steam
station
There are some water drops from the
holes in the bottom of the sole plate.
Water drops come out after a restart
from Stand by.
Brown coloured fluid leaks from the sole
plate.
The first time the appliance is
turned on, you notice smoke
The appliance emits an intermittent
noise associated with vibrations.
The appliance emits a continuous noise
associated with vibrations.
The steam generator cap is difficult to
unscrew
After topping up with water, the light
does not reset.
All LEDs are blinking
The icons and are blinking
Subject to change without notice. Please do
not dispose the product in the household
waste at the end of its useful life. Disposal
can take place at a Braun Service Centre or
at appropriate collection points provided in your
country
DLB231614_5712811681_IS5022_UI_INT_AUNZ.indb 11
All manuals and user guides at all-guides.com
CAUSE
The appliance is not plugged into a
mains socket.
The "max" pressure safety system has
opened.
Water has condensed inside the tubes
because steam is being used for the
first time, or has not been used for
some time
The thermostat knob is not in the
correct position.
The iron has not reached the
temperature.
Chemical water softeners or additives
have been poured into the water tank or
steam generator.
Some parts have been treated with
sealer/lubricant which evaporates the
first time the iron heats up.
Water is being pumped into the steam
generator.
Limescale has made the steam
generator cap difficult to open
The water float doesn't work
appropriately
System error
Accidentally the reset button was
pressed instead of ON/OFF button.
REMEDY
Make sure the appliance is correctly
connected and press the on/off button.
Turn the appliance off immediately and
contact an authorised Braun Customer
Services
Press the steam button several times
away from the ironing board. This will
eliminate cold water from the steam
circuit.
Place the thermostat knob in the •••
(3 dots) sector.
After re-start from Stand by, wait
until temperature control light has
turned off.
Never pour products into the water tank.
Clean the sole plate with a damp cloth.
This is normal and will stop when you
have used the iron a few times.
This is completely normal
Unplug the system from the mains and
contact an authorised Braun Customer
Services.
Turn the cap forcefully. To avoid the
problem, rinse the steam generator
frequently
Empty the water tank, rinse out it and
refill.
Unplug the system, plug it again and
press ON/off button. If this problem is
still present, Turn the appliance off
immediately and contact an authorised
Braun Customer Services.
Unplug and plug again
24.11.14 16:32
11