Beko HCA62641BH Bedienungsanleitung Seite 12

5 Installation Of Appliance
the length of bolts.
The bolts and dowels provided are suit-
•
able for brick walls. For other construc-
tion material (e.g. drywall, plate, porous
concrete), suitable fixing dowels and
nuts shall be used.
(Figure 7)
CAUTION
A
Before drilling, ensure that there
are no power, gas or water pipes
in the close proximity of the drilling
locations.
Draw a mid location line from the ceiling
perpendicular to the lower edge of the
hood.
Paste the installing template provided
within the accessories on the surface
where the hood is to be mounted. In do-
ing this operation, observe the mounting
height of the hood (Page 12 / Figure 6).
There is a tab in the middle of the flue
connection plate. Place the middle point
of this tab on the line that is drawn per-
pendicular to the wall. In doing this op-
eration, adjust the hood according to the
12 / EN
maximum height (Page 8 / Figure 1). Mark
the holes where the flue connection plate
will be mounted with the help of a pen
(Figure 7/a).
Drill the marked points with Ø6mm drill
and insert 2 plastic dowels in the drilled
holes (Figure 7/a). Fix the flue connection
plate to the wall with 3,9x22 screws (Fig-
ure 7/a).
To assemble the hood body, you can use
the Ø8mm drill bit to drill points A, B, C,
D on the assembly template, and insert
4.8x50mm plastic dowels at these points.
(Figure 7/b).
2 piece 4.8x50 suspension screw with
a clearance of 5 mm between the screw
head and the wall (Figure 7/b).
(Figure 8)
1. Hanger Plate
2. Hanging Plate Connection Screw
In order to install your hood to the wall,
loosen the screws on the hanger plates
mounted on the motor cabin and pull them
up, and then fasten again (Figure 8 / A).
Turn on the suction glass of the hood and
remove the aluminum grease filter (Page
11 / Figure 4).
Cooker Hood / User Manual