AEG IAE84853FB Benutzerinformation Seite 23

Problem
The display does not react to the
touch.
An acoustic signal sounds and the
hob deactivates.
An acoustic signal sounds when the
hob is deactivated.
The hob deactivates.
Residual heat indicator does not
come on.
You cannot activate the highest heat
setting.
The sensor fields become hot.
Hob²Hood does not work.
Hob²Hood operates, but only the
light is on.
Hob²Hood modes H1 - H6 operate,
but the light is off.
There is no sound when you touch
the panel sensor fields.
Wrong language is set.
The flexible induction cooking area
does not heat up the cookware.
Possible cause
Part of the display is covered or the
pots are placed too near to the dis‐
play.
There is some liquid or an object on
the display.
You put something on one or more
sensor fields.
You put something on the sensor
field .
The zone is not hot because it oper‐
ated only for a short time or the sen‐
sor under the hob surface is dam‐
aged.
Another zone is already set to the
highest heat setting.
The Power limitation level is too low. Change the maximum power in the
The cookware is too large or you put
it too near to the controls.
You covered the control panel.
You activated the H1 mode.
There might be a problem with the
light bulb.
The sounds are deactivated.
You changed the language by mis‐
take.
The cookware is in a wrong position
on the flexible induction cooking
area.
Remedy
Remove the objects. Move the pots
away from the display.
Clean the display, wait until the ap‐
pliance is cold. Disconnect the hob
from the electrical supply. After 1
min, connect the hob again.
Remove the object from the sensor
fields.
Remove the object from the sensor
field.
If the zone operated sufficiently long
to be hot, speak to an Authorised
Service Centre.
First reduce the power of the other
zone.
Menu. Refer to "Daily use".
Put large cookware on the rear
zones, if possible.
Remove the object from the control
panel.
Change the mode to H2 - H6 or wait
until the automatic mode starts.
Contact an Authorised Service Cen‐
tre.
Activate the sounds. Refer to "Daily
use".
Reset all functions to the factory set‐
tings. Select Reset All Settings from
the Menu.
Disconnect the hob from the electri‐
cal supply. After 1 min, connect the
hob again. Set Language, Display
Brightness and Buzzer Volume.
Place the cookware in the correct
position on the flexible induction
cooking area. The position of the
cookware depends on the activated
function or function mode. Refer to
"Flexible induction cooking area".
ENGLISH 23