Porsche Mobile Charger Connect Anleitung Seite 69

Connection via PLC pairing button
1. Select PLC linking button.
2. Start the connection process on the PLC modem.
Confirm by pressing OK on the charger.
Once the setup is connected, confirm with Con-
nect.
�� The connection to the PLC network is active.
If a connection to the PLC network is established, the
symbol will be displayed in the status bar.
Connection via PLC security code
A device containing the control software for the PLC
network must be used for this method.
1. To establish a connection to a PLC network us-
ing the security code, select PLC security code.
�� The security code appears on the display.
2. Enter the security code in the relevant menu
of the control software for the PLC network to
integrate the charger in the PLC network.
�� The connection to the PLC network is active.
If a connection to the PLC network is established, the
symbol will be displayed in the status bar.
Information
PLC characteristics:
–
Separate interfaces to the vehicle and to the
infrastructure
–
PLC to IEEE P1901
–
Home Plug AV
– Encryption: 128-bit AES
– Frequency band: 2-30 MHz
User profiles (pairing Porsche ID)
When the charger is paired with your Porsche ID,
information about the charger and the charging pro-
cesses can be displayed in My Porsche and in the
Porsche Connect app.
To pair the charger with your Porsche ID:
e
Open the website shown on the charger display
in the browser of your device and enter the user
code.
– or –
Scan the QR code displayed on the charger. You
can scan the QR code in the following ways:
–
Using the Porsche Connect app (My Ac-
count > Charging cables & devices > Scan
QR code).
– Using the camera on your device (iOS 11 or
higher, different for Android).
– Using an app for scanning QR codes.
If the charger has been paired successfully, the In-
stallation assistant moves on to the next step.
Connecting the energy manager
If an energy manager is available, you can establish a
connection to it. The energy manager then assumes
control of the charging process.
e
For instructions for connecting, refer to the en-
ergy manager operating manual.
If there is no energy manager available, the vehicle
will be charged at the charging current entered on
the charger:
e e Adapt charging current
Settings
g Refer to chapter "Adapt charging current" on
page 67.
Hotspot
If integration in a home network is not possible, the
charger can activate a hotspot and use this to es-
tablish a connection to the Web Application of the
charger.
e
To establish a hotspot, click Activate hotspot.
Once a hotspot has been established, the
appears in the status bar.
Information
If you use an Android system, you may need to con-
firm separately that the connection has been estab-
lished, so that a hotspot connection can be estab-
lished.
Adapt charging current
If no energy manager is available in the home net-
work, the maximum permitted charging current for
the charger can be set here.
The displayed maximum value is determined by the
types of cable that are connected.
e
Set the charging current to the maximum value
available in the mains supply used for the
charger. Use Plus and Minus to do this.
g Refer to chapter "Charging current limiting" on
page 71.
Device protection
To prevent an unauthorised vehicle from being con-
nected to the charger, a PIN prompt can be set up.
1. To activate the PIN prompt, select On.
2. Enter a 4-digit PIN and confirm.
symbol
67