Long-Term Shutdown; Disposal Of Device - EKOM DK50 4VR/50 Benutzerhandbuch

PRODUCT MAINTENANCE
 Connect the cabinet to the compressor by inserting the power cord with connector into a power
socket. (Fig. 13)
 Connect the device to the electrical mains
 Activate the compressor by turning on the switch on the pressure switch and the switch (4) on
the cabinet (Fig. 14).
Compressor with cabinet - when operating in the cabinet, there must not be an electrical
connection. (Fig. 20 pos. A,B, Fig. 21 pos A).
Note: In case of using a compressor without a cabinet or in case of maintenance, a jumper
which is not installed into the terminal strip should be kept in a designated place next to the
electrical panel.
17.12. Cleaning and disinfection of the exterior surfaces of the product
Clean and disinfect the exterior surfaces with neutral cleaning products.
Use of aggressive detergents and disinfectants containing alcohol and chlorides
can lead to surface damage and discolouration.

18. LONG-TERM SHUTDOWN

If the compressor is not going to be used for long period, it is recommended to drain all condensate
from the air tank and switch on the compressor for about 10 minutes, keeping the drain valve open.
Thereafter switch off the compressor using the switch (2) on the pressure switch (1) (Fig. 14), close
the drain valve and disconnect the device from the mains.

19. DISPOSAL OF DEVICE

 Disconnect the equipment from the mains.
 Release the air pressure in the pressure tank by opening the drain valve.
 Dispose of the equipment following all applicable regulations.
 Entrust a specialised company to sort and dispose of waste.
 Worn out components have no negative environmental impact.
08/2021 53 NP-DK50 4VR 50, DK50 2x4VR 110-A-2_08-2021-MD