YEAZ PARADISE BEACH-EXOTREK Bedienungsanleitung Seite 16

INFLATION
Insert the hose nozzle into the board's valve and
turn the attachment clockwise. After inflation,
remove the hose and close the safety cap of the
valve to seal it permanently.
Using a compressor can damage your item; all
warranty claims are void if a compressor is used.
CAUTION: If you expose the paddleboard to
the hot sun, please check the air pressure and
release a little air, otherwise the material could
be overstretched. The ambient temperature
affects the internal pressure of the chambers: a
deviation of 1°C results in a pressure deviation in
the chamber of +/-4 mBar (.06 PSI).
MOUNTING THE FIN
Align the fin in the same way as the two fixed fins. Loosen the screw completely from the fin. Then
lightly screw the loose screw back into the square nut. This makes it easier to position the nut in
the rail. Now insert it into the opening in the middle of the rail. Then use the screw to push the
square nut into the desired position and now loosen the screw completely. The nut remains in
the guide rail. Now insert the fin with the brass bolt first at the opening of the rail in tilted position,
then straighten it and push the fin until the hole is directly above the square nut and fix the fin in
it with the screw.
1
2
3
16
4
5