Herunterladen Inhalt Inhalt Diese Seite drucken

Setting And Starting A Washing Programme - Küppersbusch IGV6504.0 Benutzerinformation

Geschirrspülmaschine
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

28
5. Close the lid of the detergent dispenser.
Press the lid until it locks into position.
Different brands of detergent dissolve in
different times. Some detergent tablets
do not have the best cleaning results
during short washing programmes. Use
long washing programmes when you
use detergent tablets to fully remove the
detergent.
Use of combi detergent tablets
These tablets contain agents such as deter-
gent, rinse aid and dishwasher salt. Some
types of tablets can contain other agents

Setting and starting a washing programme

Important! Set the half-load option before
the start of a washing programme. You
cannot set the option when a washing
programme operates. If it is necessary to set
the half-load option, cancel the washing
programme.
Set the washing programme with the
door ajar. The washing programme only
starts after you close the door. Until then
it is possible to modify the settings.
Do these steps to set and start a washing
programme:
1. Switch on the appliance.
2. Make sure that the appliance is in setting
mode.
3. Press the programme selection/cancel
button again and again to set the washing
programme. Refer to the chapter 'Wash-
ing programmes'.
All manuals and user guides at all-guides.com
When you use tablets, that contain special
salt and rinse aid, it is not necessary to fill the
salt and rinse aid containers. In this condition
the rinse aid indicator light stays on when the
appliance is switched on.
1. Do a check if these tablets are applicable
2. Select the lowest setting for the water
Do these steps if the drying results are not
satisfactory
1. Fill the rinse aid dispenser with rinse aid.
2. Set the rinse aid dosage to position 2.
To use normal detergent again
1. Fill the salt container and rinse aid dis-
2. Adjust the water hardness setting to the
3. Do a washing programme without
4. Adjust the water softener to the water
5. Adjust the rinse aid dosage.
4. Close the door.
Cancelling a washing programme
1. Press and hold the programme selection/
for the local water hardness. Refer to the
instructions from the manufacturer.
hardness and rinse aid dosage.
penser.
highest level.
dishes.
hardness in your area.
– The programme indicator light comes
on.
– The washing programme starts auto-
matically.
When the washing programme oper-
ates, you cannot change the pro-
gramme. Cancel the washing pro-
gramme.
Warning! Only interrupt or cancel a
washing programme if necessary.
Caution! Open the door carefully. Hot
steam can come free.
cancel button until:
– the programme indicator light goes off.
– The end-of-programme indicator light
starts to flash.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis