Technoline WS 1600 Kurzbedienungsanleitung Seite 21

SETTING UP:
1. Unwind the cable of the Rain and the Wind sensors. Connect the Rain and the
Wind sensors to the Thermo-hygro transmitter by plugging the connector head of
the two sensors to the appropriate sockets of the Thermo-hygro transmitter.
2. First insert the batteries into the Thermo-hygro transmitter (see "How to install
and replace the batteries into the Thermo-hygro transmitter" below).
3. Then insert the batteries into the Weather Station (see "How to install and
replace the batteries into the Weather Station" below). Once the batteries
are installed, all segments of the LCD will light up briefly and a short signal
tone will be heard. It will then display the time as 0:00, the date as 1.1.05, the
weather icons, and air pressure value. "- - -" will be shown for outdoor data.
4. Afterwards the Weather Station will start receiving data from the transmitter.
The outdoor temperature, humidity wind chill and wind speed should then be
displayed on the Weather Station. If this does not happen after 30 seconds, the
Sockets for wind
and rain sensor
21