Electrolux 7000 service Bedienungsanleitung Seite 20

20
• The selected level of the water softener
is not appropriate for the hardness of
your water supply.
Poor drying results
• Tableware has been left too much time
inside a closed appliance.
• The selected programme has no drying
phase.
• The selected programme has a drying
phase with low temperature.
• The dosage of rinse aid is not enough.
Set the rinse aid dispenser to a higher
level.
• There is no rinse aid in the rinse aid
dispenser.
• Plastic items may need to be towel
dried.
• Dishes have not been arranged properly
in the baskets.
• Arrange the tableware avoiding, if
possible, contact points. This will allow
water to reach all surfaces.
• Arrange kitchen utensils in a sloping
position.
• The interior of the appliance is wet
caused by the humidity in the air that
condenses on the inner sides of the
appliance. This is not a defect of the
appliance.
• Multi-tablets may give poor drying
results. Try a different brand of multi-
tablets. The use of rinse aid together
with multi-tablets can help to increase
drying performance.
• The cutlery is not dry. Cutlery has not
been arranged properly in the cutlery
basket.
Traces of rust on cutlery
• A lower grade of stainless steel of the
cutlery is less resistant to corrosion in
damp dishwasher environment. Use high
grade stainless steel or remove the items
from the appliance immediately after the
end of the programme.
• There is too much salt in the water used
for washing. This could be caused by
the salt cap that is not correctly closed
or if the salt container has been
replenished recently, a quantity of salt
was spilled in the tub.
• Silver and stainless steel cutlery were
placed together. Avoid to put silver and
stainless steel items close together.
Limescale deposits on the
tableware, on the tub and on the
inside of the door
• The is no salt in the salt container.
• The selected level of the water softener
is not appropriate for the hardness of
your water supply.
• The tap of the salt container has not
been properly closed.
• The quantity of detergent was not
enough.
• The detergent was not suitable.
Visible bluish film on glasses
and cutlery, on the tub and on
the inside of the door
• The dosage of rinse aid is too much. Set
the rinse aid dispenser to a lower level.
Chipped tableware
• Place all items carefully in the baskets
and do not overload.
• Place delicate items in the upper basket.
• Place glasses so they do not touch each
other and cannot move during the
washing.
• Move baskets in and out slowly.
• Make sure that items do not touch the
top of the tub when the upper basket is
pushed in.
• Fine antique china and crystal should be
hand-washed.
Excess of moisture on the
baskets and inside the
appliance
• There is no rinse aid in the rinse aid
dispenser.
Odours inside the appliance
• When the appliance is installed for the
first time, there will be the ''new'' smell.