Troubleshooting - Optelec ClearView+ Bedienungsanleitung

Optelec
6.

Troubleshooting

Manufacturer's default settings
If you experience any difficulty operating the system,
reset the factory default settings. Switch the ClearView
off and wait 3 seconds. Then press and hold the On / Off
button till the red ring light starts flashing.
No image on the ClearView
on
- Check all cables and hardware are connected properly
and securely.
- Check that the unit is receiving power by verifying that
the green indictor LED light is lit on the power supply.
- Ensure sure the monitor is switched on if a non-
ClearView
Image is not in focus
- Check the auto-focus lock (the lit red circle around the
mode button means that the focus is locked). Press the
focus button to return to auto-focus mode.
- Carefully clean the mirror on the camera unit with a
non-abrasive cloth.
- Clean the monitor screen with a non-abrasive cloth.
Pictures and text look gray or have low contrast
- Press the mode button to switch to the high contrast
reading mode.
- Adjust the image control or brightness level on the
control panel.
- If you are using a non-ClearView
monitor's brightness and contrast settings .
English
+ monitor is connected.
+
monitor after it is switched
+ monitor, modify the
ClearView +
+
23