Assembly Of Central Rotor And Cutting Mechanism - Kobra SSD Betriebsanleitung

REMOVAL OF THE CENTRAL ROTOR
If during the inspection of the central rotor it becomes clear that the rotor needs sharpening, proceed as
follows:
Remove the flange "A" by unscrewing the retaining screws.
-
- Screw on two M10 x 80 screws "B" in order to get a better grip and then remove the central
rotor by pulling it out as shown in the diagram.
N.B.! This operation needs to be carried out by qualified personnel and at least two people.
REASSEMBLY OF THE CENTRAL ROTOR
After it has been sharpened, the central rotor must be replaced as follows:
Position the central rotor aligning the keyway "A" with the key "B" located on the support
-
shaft.
Push the central rotor in as far as it will go
-
Remove the screws "C".
-
Reposition the flanges in the order shown in the diagram (1-2-3-4) and secure them with
-
the screws which had been taken out.
N.B.! This operation needs to be done by qualified personnel and at least two people.
34